SCREW RECOVERY

We offer both full floor recovery or partial recovery with our screw system.​

​

The initial cost of the foundation work is very quickly offset by the trouble free and economical screw system.

 

A popular screw set up is with a screw down either side of the blast area directly below the loose hanging rubber.  These feed the abrasive into the cross screw which is set at 90° to the recovery screws and in turn feeds the belt and bucket elevator situated outside of the blast area.

 

The screws are manufactured from a centre tube and a spiral flight down the full outside length of the screw.  At one end of the screw we fit a shaft that runs freely in a fitted self lubricating bearing.  At the other end we fit an extended drive shaft with with a self lubricating bearing and a motor gearbox.  These screws are fitted into a steel trough which encases the abrasive allowing it to be transported along the length of the unit to the elevator.